Installation / Clawbrowser demo / 4:18

Set up Clawbrowser on Linux with Docker and Hermes

Follow Linux browser installation with Docker and Hermes, including runtime startup and the verification mismatches shown in the recording.

Published · @next_ossaiWatch on YouTube ↗

Overview

Before Hermes can complete browser tasks, it needs a working connection to a browser runtime. This guide accompanies the Linux, Docker and Hermes installation video and separates preparation, integration, and a first-session check. Use it to understand what to verify before starting research or automation.

What happens in the video

The recording uses a Telegram bot conversation to install the Linux runtime and configure an API key. Its final report shows a running portable Xvfb browser and a reachable endpoint, but also reports mismatches in platform, hardware concurrency, screen, media devices, and battery checks. This demonstrates a launched session with unresolved verification issues.

Before you start

  • A Linux host with Docker and Hermes available.
  • A Clawbrowser account and API key available through your normal credential setup.
  • The current installation guide linked below.

Step-by-step guide

Practical steps for adapting the recorded task. The video summary above describes the demonstrated result; these checks guide your own run.

  1. Prepare the environment

    Start with a Linux host with Docker and Hermes available. Read the current installation guide and choose this environment. Check the boundary between the host, the browser container, and Hermes. The endpoint must be reachable from the agent environment; localhost inside one container does not refer to another container.

  2. Install the runtime

    Follow the official workflow to install Clawbrowser and its control tooling. The video gives a visual reference for Linux, Docker and Hermes; the installation guide is the source for current commands and packages.

  3. Connect the agent

    Complete the integration for Hermes and provide the account configuration requested by setup. Confirm that the agent can discover its browser tools before asking it to perform a website task.

  4. Verify a first session

    Inspect the verification result before using the session. The recorded report lists platform, hardware, screen, media-device, and battery mismatches despite a successful launch. Diagnose those failures and run verification again; opening a page alone does not resolve them.

Try this prompt

Suggested prompt

Follow https://clawbrowser.ai/docs/install/ to set up Clawbrowser for Hermes in my Linux, Docker and Hermes environment. Use the current instructions, connect the browser tools, then open https://example.com and report the page title and URL. Explain any setup step that fails.

Adapt the placeholders to your task. This is an example prompt, not a transcript of the recording.

Results

  • A running Linux portable browser and endpoint reported by the agent.
  • Unresolved fingerprint-check mismatches in the final report; installation alone is not a clean verification result.

Questions about this workflow

Does installing the browser automatically connect Hermes?

Treat these as separate checks. Verify that Hermes can discover the browser tools and successfully inspect a page.

Should I copy commands from the recording?

Use the current installation guide for commands and downloads. The video is a visual walkthrough and may show an earlier interface.

Does this recording show every verification check passing?

No. The final report lists several fingerprint mismatches. It demonstrates runtime startup, but those failures still need diagnosis.

Put the workflow to work

Prepare the browser connection, then adapt the guide to your task and check its output.

Set up Clawbrowser →

Related reading

Explore the broader use case

Guide reviewed . Source: published video and description.

Related video guides